Made of plastic with different internal diameters from 22 mm through 26 mm, up to 32 mm.
Compatible with all forbuild pulls, the special rough surface of the tube improves its adhesion to concrete.
The plastic spacer tube together with the cones is designed to protect the drawstring from dirt and allow it to be reused.
In places of low water pressure, the tube is clogged with a FLUPP stopper, and the whole is blinded with a concrete stopper, which is glued with AB-Plus two-component glue.
Use:
As a cover for formwork and drawstring in the water partition.
Care should be taken to ensure that the plastic spacer K is not longer than 600 mm.
If such a situation occurs, the half-length tube should be cut and connected using a D22 spacer tube fitting, which increases the rigidity of the casing tube.
Compatible with all forbuild pulls, the special rough surface of the tube improves its adhesion to concrete.
The plastic spacer tube together with the cones is designed to protect the drawstring from dirt and allow it to be reused.
In places of low water pressure, the tube is clogged with a FLUPP stopper, and the whole is blinded with a concrete stopper, which is glued with AB-Plus two-component glue.
Use:
As a cover for formwork and drawstring in the water partition.
Care should be taken to ensure that the plastic spacer K is not longer than 600 mm.
If such a situation occurs, the half-length tube should be cut and connected using a D22 spacer tube fitting, which increases the rigidity of the casing tube.