KB1 Vag usb obd cable ii-4 xline

Website to check compatibility with a given make/model/engine version of the car! Before buying an interface, check exactly what protocol your car model uses! https://www.outilsobdfacile.com/vehicle-list-compatible-obd2/

REMARK! Commercial programs (paid) may have protection against the use of interface clones (which applies to our diagnostic products). It is best to use free applications

In case of further problems, check the clone settings in the settings of the application and disable them!

• 1. Engine Electronics
• 2. ABS system
• 3. SRS airbags
• 4. Immobiliser - matching new keys
• 5. Central locking, alarm - factory
• 6. Automatic transmission
• 7. Counters and indicators
• 8. Radio, navigation system, television
• 9. Additional heating system (webasto or other type)
• 10. Air conditioning
• 11. Parking assistance system
• 12. Adjustable light range (xenon)
• 13. Sunroof

It allows you to diagnose the following car models:

• VW Polo until 2007
• Seat Ibiza until 2007
• Skoda Fabia I until 2007
• Skoda Octavia I until 2007

and cars equipped with an OBD2 connector and using the ISO 9141 standard until 2004.

The interface in AUDI, SEAT, SKODA, VOLKSWAGEN cars enables:

With the help of the interface, you can diagnose all the systems in the car, thanks to which you can detect the fault very quickly, the software allows in a very simple way:

Delete fault codes (AIR BAG, ABS, IMMOBILIZER, ENGINE, ETC.),

Oil inspections with both a fixed periodic interval and a variable periodic interval,

View the parameters of the car while driving (engine, boost pressure, injection times, temperature, flow meter, indicators, etc.)

With a little experience, you can also:

Adapt new components in the car (injection angle, throttle, speed and ignition control, etc.)

Program the immobilizer

Adjust the meter (undo the meter)

In addition, if you choose the right controller, e.g. an engine computer, it is possible to read error codes, delete them, diagnose actuators such as dampers valves, sensors. Dynamic checking of ignition, starting dose, checking the condition of the engine based on the wear of individual cylinders - that is, the difference in fuel doses dosed by the computer to individual cylinders so that the engine runs evenly at idle .

You do not have to go to an authorized service station with any problem, they also have such a device and also make repairs on its basis. The interface was created as an alternative to original devices such as 1551 or VAS. The cost of the device is disproportionately small compared to the above-mentioned and the possibilities are much greater than even the KTS 5xx.

PC with Pentium III or later

256 MB RAM

USB port 

(copy the link to your browser's address bar and click Enter)

http://support.aptel.pl/admin/uploads//KB1_CH341SER.rar