Car window damage repair kit. Get rid of ugly spider veins from the glass and protect the chips from further widening.
Product features:- With this kit, you can repair the window in your car yourself. You will easily and quickly get rid of chips caused most often by stone impacts from under the wheels of other cars.
- Chips and deep scratches resulting from cracks will become almost invisible, and the glass will be protected against further increase in damage.
- Suitable for repairing damage to glass in the shape of small meshes, once longitudinal cracks no longer than 15cm.
- Thanks to the large amount of glue in the kit, the set is suitable for reusable use.
- It pays for itself on the first use, the cost of repairing them is many times lower than in authorized car services.
- Quick effect - the entire procedure of applying the glue takes a few minutes, and the glue itself dries within 10 minutes of exposure to sunlight (UV glue).
Before starting work, it is necessary to clean and degrease the glass on both sides. Any remnants of the glass in the form of chips and small crumbs should also be removed.
- Fasten the fastening cross with suction cups to the glass so that its central hole is directly above the crack.
- In the middle hole of the mounting cross, screw the applicator with the screw (piston) so that the end of the applicator is in contact a little more strongly with the center of the crack, then unscrew the piston from the applicator.
- Place the correct amount of glue in the applicator (depending on the size of the crack). Usually, 5-10 drops are enough for less damage (4-7mm in diameter).
- Screw the piston into the applicator to the resistance, then unscrew and screw in again (preferably several times) the piston in the applicator, so that the glue can get into as many nooks and crannies as possible while pushing air out of the damage. By screwing in the piston, observe whether the glue spreads in the damage completely filling it. If necessary, add another portion of glue. Glue should completely fill the damage.
- Unscrew the plunger from the applicator.
- Wait for the vacuum to drain the air from under the applicator.
- Screw the plunger back in to the limit. Make sure the damage is completely filled.
- Unscrew the plunger and applicator.
- Remove the fixing cross.
- Apply 2 drops of glue to the sealed damage and cover the protective film by pressing it gently so that no air bubbles remain under it.
- Expose for 10 minutes to the sun or irradiate with a UV lamp. The process of curing the adhesive occurs only under the influence of UV radiation.
- The included razor blade scrapes off excess glue (with quick gentle movements at an angle of 90°, without worrying about scratching the glass).
- In the case of a longer longitudinal crack, apply glue along the crack (without using an applicator) and then line the entire length of the crack with a protective film. Next, follow the previous instructions.
- In case of possible shortcomings in gluing, the procedure should be repeated.
- Suction cup ring
- Glue applicator
- Glue
- Razor blade with secure handle
- Foil strips
- Manual
- The whole is packed in an aesthetic blister